888-409-7665

We continue this site as it helps you find us.  We encourage you to visit our new site at www.foalingcamera.com

 
Remington Sequential Switcher

For multiple stall monitoring, we recommend a sequential switcher over the standard quad processor.  The switchers dwell time may be adjusted to suit your needs.  Manual override will allow you to single out a particular stall for the night.  The switcher allows you to view the entire frame at it's maximum resolution.  Quad processors reduce each stall to 25% of it's original resolution making it difficult to make anything out.  The Remington Switcher will accept up to 4 cameras.  This switcher is compatible with the Bullet Wireless System and all Hard Wired Cameras.  It is placed in series prior to the transmitter.

Key Benefits

Pricing

Multiple cameras on All-in-one setup

It is possible to operate up to 4 cameras on the all-in-one camera setup.  Keep in mind that the cameras directional antennas must point in the same general direction so that they may utilize a receiver.  Each receiver is capable of picking up up to 4 cameras.  Standard range cameras are available on all four channels.  The FCC limits us to two channels on the high power model.  The receiver is included with your initial camera system.  Standard receivers (3db) have an auto switcher built in.  High power receivers (6db) must be manually switched with a selector button located atop the receiver.  Additional receivers are also available should you need to monitor camera(s) from more than one location.